Removal

1UR-FSE CHARGING: GENERATOR: REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH





(a) Remove the 6 clips and cowl top ventilator louver RH.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

4. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY Removal

5. REMOVE NO. 1 AIR CLEANER INLET Removal

6. REMOVE NO. 1 ENGINE UNDER COVER Service and Repair

7. REMOVE FRONT SUSPENSION MEMBER PROTECTOR LOWER Removal

8. REMOVE NO. 2 ENGINE UNDER COVER Removal

9. REMOVE INTAKE AIR CONNECTOR PIPE Removal

10. REMOVE V-RIBBED BELT Removal

11. REMOVE GENERATOR





(a) Remove the nut, and disconnect the harness from the +B terminal.

(b) Disconnect the generator connector.

(c) Remove the 2 bolts and 2 nuts.





(d) Using an E8 "TORX" socket wrench, remove the 2 stud bolts and generator.