Removal

LIGHTING: HAZARD WARNING SWITCH: REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* w/ Navigation System (for HDD):
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

5. REMOVE SHIFT LEVER KNOB Removal

6. REMOVE NO. 3 BOX PANEL Removal

7. REMOVE REAR CONSOLE PANEL UPPER Removal

8. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER Removal

9. REMOVE RADIO RECEIVER ASSEMBLY Removal

10. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY (w/o Multi-display) Removal

11. REMOVE MULTI-MEDIA MODULE DISPLAY ASSEMBLY (w/ Multi-display) Removal

12. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

(a) Disconnect the connector.





(b) Detach the 2 claws and remove the hazard warning signal switch.