Removal

NAVIGATION: DISPLAY AND NAVIGATION ASSEMBLY: REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
* w/ Navigation System (for HDD):
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

6. REMOVE NO. 3 BOX PANEL Removal

7. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY Removal

8. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

9. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET Removal

10. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY WITH BRACKET





(a) Remove the 2 bolts.

(b) Pull the display and navigation module display with bracket to detach the 6 clips on the backside of the display and navigation module display with bracket.

(c) Disconnect the connectors and remove the display and navigation module display with bracket.





11. REMOVE NO. 2 RADIO BRACKET





(a) Remove the 2 bolts and bracket.

12. REMOVE NO. 1 RADIO BRACKET





(a) Remove the 2 bolts and bracket.