Installation

PARKING BRAKE: PARKING BRAKE CABLE: INSTALLATION

1. INSTALL CABLE SUPPORT BRACKET

(a) Install the cable support bracket with the 2 nuts.

Torque : 76 Nm (775 kgf-cm, 56 ft-lbf)

2. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Install the 2 cable support brackets to the No. 3 parking brake cable assembly.

(b) Install the No. 3 parking brake cable assembly to the cable support bracket with the 2 nuts.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(c) Install the No. 3 parking brake cable assembly to the body with the 2 bolts and 2 clamps.

Torque : 19 Nm (194 kgf-cm, 14 ft-lbf)

3. INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR Installation

4. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY

HINT
Use the same procedure for the No. 3 parking brake cable assembly.

5. INSTALL NO. 1 DIFFERENTIAL SUPPORT PROTECTOR Installation

6. APPLY HIGH TEMPERATURE GREASE Reassembly

7. INSTALL PARKING BRAKE SHOE LEVER SUB-ASSEMBLY Reassembly

8. INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY Reassembly

9. INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY Reassembly

10. INSTALL PARKING BRAKE SHOE ADJUSTING SCREW SET Reassembly

11. INSTALL NO. 1 PARKING BRAKE SHOE RETURN TENSION SPRING Reassembly

12. INSTALL NO. 2 PARKING BRAKE SHOE RETURN TENSION SPRING Reassembly

13. INSPECT PARKING BRAKE INSTALLATION Reassembly

14. INSTALL REAR DISC Installation

15. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY Reassembly

16. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY

(a) Pass the No. 1 parking brake cable assembly through the parking brake control pedal assembly, and install the clip to the No. 1 parking brake cable assembly.

(b) Install the No. 1 wire adjusting nut to the No. 1 parking brake cable assembly.

(c) Bend the claw of the parking brake control pedal assembly to hold the No. 1 parking brake cable assembly.

17. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

HINT
Refer to the instructions for Installation of the parking brake control pedal assembly Installation.

18. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)