Installation

2GR-FSE ENGINE CONTROL SYSTEM: KNOCK SENSOR: INSTALLATION

1. INSTALL KNOCK SENSOR

(a) Install the 2 knock sensors so that they are horizontal as shown in the illustration. Then install the 2 bolts.





Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

HINT
It is acceptable for the sensor to be tilted +10° to -5°.

(b) Connect the 2 knock sensor connectors.

2. INSTALL FUEL INJECTOR SEAL Installation

3. INSTALL INJECTOR Installation

4. INSTALL NO. 1 FUEL DELIVERY PIPE Installation

5. INSTALL NO. 2 FUEL DELIVERY PIPE Installation

6. INSTALL NO. 3 FUEL PIPE Installation

7. INSTALL NO. 2 FUEL PIPE Installation

8. INSTALL FUEL PUMP ASSEMBLY Installation

9. CONNECT NO. 2 FUEL PIPE Installation

10. INSTALL NO. 1 FUEL PIPE Installation

11. INSTALL FUEL PRESSURE PULSATION DAMPER Installation

12. INSTALL WATER HOSE JOINT Installation

13. INSTALL INTAKE MANIFOLD Installation

14. INSTALL INTAKE AIR SURGE TANK ASSEMBLY Installation

15. INSTALL THROTTLE BODY Installation

16. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE Installation

17. CONNECT NO. 2 VENTILATION HOSE Installation

18. ADD ENGINE COOLANT Testing and Inspection

19. INSPECT FOR COOLANT LEAK Testing and Inspection

20. INSPECT FOR FUEL LEAK Testing and Inspection

21. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation

22. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH Installation

23. INSTALL WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH Installation

24. INSTALL FRONT WIPER ARM HEAD CAP Installation

25. INSTALL ROOF DRIP SIDE FINISH MOULDING LH

26. INSTALL ROOF DRIP SIDE FINISH MOULDING RH

27. INSTALL FRONT FENDER PROTECTOR UPPER LH Installation

28. INSTALL FRONT FENDER PROTECTOR UPPER RH Installation

29. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

30. INSTALL ENGINE ROOM SIDE COVER LH Installation

31. INSTALL ENGINE ROOM SIDE COVER RH Installation

32. INSTALL COOL AIR INTAKE DUCT SEAL Installation

33. CHECK FUNCTION THROTTLE BODY Inspection