Removal

BRAKE: HYDRAULIC BRAKE BOOSTER: REMOVAL

NOTICE:
Before starting the procedures, make sure that the ignition switch is OFF and depress the brake pedal more than 40 times.

HINT
When the power supply system's pressure is released, the brake pedal resistance decreases.

NOTICE:
* As high pressure is applied to the No. 1 brake actuator tube, make sure that it does not deform.
* Do not turn the ignition switch ON until the procedures are completed.
1. FOLLOW PRECAUTION

(a) Follow the precaution Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

3. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.

4. REMOVE V-BANK COVER Removal

5. REMOVE BRAKE MASTER CYLINDER COVER ASSEMBLY

6. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Removal

7. REMOVE FRONT DOOR OPENING TRIM COVER LH Removal

8. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Removal

9. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY Removal

10. DISCONNECT MASTER CYLINDER PUSH ROD CLEVIS Removal

11. REMOVE FRONT WHEEL LH

12. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

(a) Using a union nut wrench, disconnect the 4 brake lines from the master cylinder.

(b) Attach identification tags to the lines or write down line connection locations so that the lines can be reconnected correctly.

(d) Disconnect the 5 connectors and harness clamp from the master cylinder.

(e) Remove the 2 nuts and disconnect the brake lines from the vehicle body.

(f) Remove the 4 nuts and pull out the master cylinder.