Installation

A760H AUTOMATIC TRANSMISSION: TORQUE CONVERTER AND DRIVE PLATE: INSTALLATION

1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY Installation

2. INSTALL TRANSMISSION OIL COOLER Installation

3. INSTALL TRANSMISSION CONTROL SHAFT LEVER LH Installation

4. INSTALL TRANSFER DYNAMIC DAMPER Installation

5. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR Installation

6. INSTALL AUTOMATIC WITH TRANSMISSION TRANSFER ASSEMBLY Installation

7. INSTALL WATER BY-PASS HOSE Installation

8. INSTALL WIRE HARNESS Installation

9. CONNECT CONNECTOR Installation

10. INSTALL ENGINE REAR MOUNTING MEMBER Installation

11. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Installation

12. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY Installation

13. INSTALL DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT Installation

14. INSTALL STARTER ASSEMBLY Installation

15. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH Installation

16. INSTALL FRONT PROPELLER SHAFT ASSEMBLY Installation

17. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Installation

18. INSTALL OUTSIDE AIR GUIDE PLATE RH Installation

19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

20. ADJUST SHIFT LEVER POSITION Adjustments

21. INSPECT SHIFT LEVER POSITION A760H Automatic Transmission

22. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR Installation

23. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

24. INSTALL OXYGEN SENSOR Installation

25. INSTALL FRONT CENTER FLOOR BRACE Installation

26. INSTALL NO. 1 REAR FLOOR PANEL BRACE Installation

27. ADD COOLANT

Testing and Inspection

28. ADD AUTOMATIC TRANSMISSION FLUID

Procedures

29. ADJUST COOLANT

Testing and Inspection

30. CHECK FOR ENGINE COOLANT LEAKS Testing and Inspection

31. CHECK FOR EXHAUST GAS LEAKS Installation

32. INSTALL ENGINE UNDER COVER

33. INSTALL ENGINE ROOM SIDE COVER LH Installation

34. INSTALL COOL AIR INTAKE DUCT SEAL Installation

35. RESET MEMORY

Programming and Relearning