Installation

AIR CONDITIONING: BLOWER UNIT: INSTALLATION

1. INSTALL BLOWER ASSEMBLY

(a) Install the blower with the 2 claws and screw.





Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

(b) Install the blower with the nut.

Torque : 9.8 Nm (100 kgf-cm, 7 ft-lbf)

(c) Connect the connector.

2. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY Installation

3. INSTALL NO. 2 AIR DUCT Installation

4. INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY Installation

5. INSTALL STEERING COLUMN ASSEMBLY

for 2GR-FSE Installation

for 1UR-FSE Installation

6. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

(a) Install the instrument panel safety pad sub-assembly Installation.

7. INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY Installation

8. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation

9. INSTALL FRONT FENDER TO COWL SIDE SEAL RH Installation

10. INSTALL FRONT FENDER TO COWL SIDE SEAL LH Installation

11. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation

12. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation

13. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH Installation

14. INSTALL FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH Installation

15. INSTALL ENGINE ROOM SIDE COVER LH Installation

16. INSTALL COOL AIR INTAKE DUCT SEAL Installation

17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.