Installation

BRAKE: BRAKE PEDAL: INSTALLATION

1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

(a) Install the brake pedal support assembly with the 4 nuts and the bolt.

Nut - Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)

Bolt - Torque : 19 Nm (194 kgf-cm, 14 ft-lbf)





(b) Engage the 2 clamps and connect the stop light switch connector.





2. INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS

(a) Apply the lithium soap base glycol grease to the push rod pin.





(b) Connect the brake master cylinder push rod clevis to the brake pedal sub-assembly with the push rod pin and a new clip as shown in the illustration.

3. INSTALL BRAKE PEDAL RETURN SPRING

(a) Install the brake pedal return spring.





4. INSTALL AFS ECU Installation

5. INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY

HINT
Refer to the procedures up to "INSTALL AIR CONDITIONING UNIT". Installation