Installation

BRAKE CONTROL: STEERING ANGLE SENSOR: INSTALLATION

INSTALLATION

1. INSTALL STEERING SENSOR
2. ADJUST CENTER FRONT WHEEL
3. INSTALL TURN SIGNAL SWITCH ASSEMBLY Installation
4. INSTALL SPIRAL CABLE SUB-ASSEMBLY Installation
5. POSITION SPIRAL CABLE Installation
6. INSTALL STEERING WHEEL ASSEMBLY Installation
7. CHECK STEERING WHEEL CENTER POINT
8. INSTALL STEERING PAD ASSEMBLY Installation
9. INSTALL STEERING PAD SWITCH MODULATOR
10. INSTALL SWITCH AND VOLUME CASE
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

13. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.