Installation

SUPPLEMENTAL RESTRAINT SYSTEM: STEERING PAD: INSTALLATION

INSTALLATION
CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it Service Precautions.

1. INSTALL STEERING PAD ASSEMBLY





(a) Support the steering pad with one hand.
(b) Connect the airbag connector.
NOTE:
When handling the airbag connector, do not damage the airbag wire harness.

(c) Connect the horn connector.
(d) Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
(e) Using a T30 "TORX" socket, install the 2 screws.
Torque: 8.8 Nm (90 kgf-cm, 78 in-lbf)
2. INSTALL STEERING PAD SWITCH MODULATOR Installation
3. INSTALL SWITCH AND VOLUME CASE Installation
4. INSTALL NO. 2 STEERING WHEEL COVER LOWER
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. INSPECT STEERING PAD ASSEMBLY
(a) Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.
(b) Check that the horn sounds.
7. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

8. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.