Installation

SUSPENSION CONTROL: SUSPENSION CONTROL ECU: INSTALLATION

INSTALLATION
HINT: A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL SUSPENSION CONTROL ECU





(a) Install the suspension control ECU to the bracket with the 2 nuts.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)
- Avoid any impact to the suspension control ECU.
- Do not drop the ECU. If it is dropped, replace it with a new one.

2. INSTALL SUSPENSION CONTROL ECU WITH BRACKET





(a) Install the ECU with bracket with the nut and bolt.





(b) Connect the ECU connectors.
NOTE:
If the suspension control ECU is replaced with a new one, enter test mode and perform registration of vehicle identification information Testing and Inspection.

3. CONNECT CONNECTORS (W/ Clearance Warning ECU)
4. CONNECT CONNECTORS (W/ Parking Assist ECU)
5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation
6. INSTALL NO. 2 INSTRUMENT CLUSTER MOULDING Installation
7. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Installation
8. INSTALL INSTRUMENT PANEL LOWER Installation
9. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
10. INSTALL INSTRUMENT SIDE PANEL RH Installation
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12. INSTALL COWL TOP VENTILATOR LOUVER RH Installation
13. ADJUST VEHICLE HEIGHT
NOTE:
If the suspension control ECU has been replaced, be sure to adjust the vehicle height.

(a) Adjust the vehicle height Adjustments.
14. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

15. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.
16. ADJUST HEADLIGHT ASSEMBLY
(a) Adjust the headlight Adjustments.