Installation

SUPPLEMENTAL RESTRAINT SYSTEM: DRIVER SIDE KNEE AIRBAG ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY





(a) Connect the connector.
NOTE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Attach the clip to install the driver side knee airbag.
(c) Install the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(d) Attach the claw to install the lock lever.
(e) Install the control cable.
2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
3. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Installation
4. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation
5. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY Installation
6. INSTALL STEERING COLUMN COVER (W/O Driver Monitor Camera) Installation
7. INSTALL STEERING COLUMN COVER (W/ Driver Monitor Camera) Installation
8. INSTALL NO. 1 INSTRUMENT CLUSTER MOULDING Installation
9. INSTALL INSTRUMENT SIDE PANEL LH Installation
10. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12. PERFORM INITIALIZATION
(a) Perform initialization Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

13. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Initialization.