Removal

BRAKE CONTROL: BRAKE CONTROL POWER SUPPLY: REMOVAL

REMOVAL
NOTE:
While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE REAR FLOOR FINISH PLATE Removal
4. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal
5. REMOVE DECK TRIM SIDE BOARD LH Removal
6. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH Removal
7. REMOVE BRAKE CONTROL POWER SUPPLY COVER
NOTE:
Do not remove the cover if planning to reuse the brake control power supply.





(a) Remove the cover if planning to replace the brake control power supply.
8. REMOVE BRAKE CONTROL POWER SUPPLY ASSEMBLY
CAUTION:
Immediately after removing the brake control power supply from the vehicle, there may be an electrical charge left in the internal capacitor. If planning to inspect the inside of the brake control power supply, leave it as is for more than 24 hours (to discharge it) after removing it from the vehicle. Then perform the inspection.





(a) Remove the 3 nuts and brake control power supply.
(b) Disconnect the connector.
9. REMOVE NO. 1 BRAKE CONTROL POWER SUPPLY BRACKET





(a) Remove the 4 bolts and 2 brackets.