Installation

AXLE: STEERING KNUCKLE: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart ( Standard Bolt - Specified Torque For Standard Bolts).

1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH Installation

2. INSTALL STEERING KNUCKLE SUB-ASSEMBLY LH Installation

3. CONNECT FRONT NO. 2 SUSPENSION LOWER ARM ASSEMBLY LH Installation

4. CONNECT FRONT SHOCK ABSORBER ASSEMBLY LH Installation

5. INSTALL FRONT STABILIZER LINK ASSEMBLY LH Installation

6. CONNECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH Installation

7. CONNECT FRONT NO. 1 SUSPENSION LOWER ARM ASSEMBLY LH Installation

8. CONNECT TIE ROD ASSEMBLY LH Installation

9. INSTALL FRONT DISC BRAKE DUST COVER LH Installation

10. INSTALL FRONT DISC Installation

11. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH Installation

12. CONNECT SPEED SENSOR CONNECTOR LH Installation

13. INSTALL FRONT WHEEL
14. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT Installation

15. CHECK ABS SPEED SENSOR SIGNAL
(a) Check the speed sensor signal ( Test Mode Procedure).
16. VEHICLE PREPARATION FOR HEADLIGHT AIMING ADJUSTMENT Adjustments

17. PREPARATION FOR HEADLIGHT AIMING (Using a screen) Adjustments

18. HEADLIGHT AIMING INSPECTION Adjustments

19. HEADLIGHT AIMING ADJUSTMENT Adjustments

20. ADJUST OBJECT RECOGNITION CAMERA
(a) Adjust the object recognition camera Adjustments.