Installation

A960E AUTOMATIC TRANSMISSION: TORQUE CONVERTER AND DRIVE PLATE:

INSTALLATION

1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY Installation

2. INSTALL TRANSMISSION OIL COOLER Installation

3. INSTALL TRANSMISSION CONTROL SHAFT LEVER RH Installation

4. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR Installation

5. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY Installation

6. INSTALL WATER BY-PASS HOSE Installation

7. INSTALL WIRE HARNESS Installation

8. INSTALL CONNECTOR Installation

9. INSTALL ENGINE REAR MOUNTING MEMBER Installation

10. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Installation

11. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY Installation

12. INSTALL DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT Installation

13. INSTALL STARTER ASSEMBLY Installation

14. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH Installation

15. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Installation

16. INSTALL OUTSIDE AIR GUIDE PLATE RH Installation

17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

18. ADJUST SHIFT LEVER POSITION Adjustments

19. INSPECT SHIFT LEVER POSITION Shift Lever Assembly

20. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR Installation

21. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

22. INSTALL OXYGEN SENSOR Installation

23. INSTALL FRONT CENTER FLOOR BRACE Installation

24. INSTALL NO. 1 REAR FLOOR PANEL BRACE Installation

25. ADD COOLANT Testing and Inspection
26. ADD AUTOMATIC TRANSMISSION FLUID Procedures
27. ADJUST COOLANT Testing and Inspection
28. CHECK FOR ENGINE COOLANT LEAKS Testing and Inspection

29. CHECK FOR EXHAUST GAS LEAKS Installation

30. INSTALL NO. 2 ENGINE UNDER COVER
31. INSTALL ENGINE UNDER COVER
32. INSTALL ENGINE ROOM SIDE COVER LH Installation

33. INSTALL COOL AIR INTAKE DUCT SEAL Installation

34. RESET MEMORY Programming and Relearning