Installation

A960E AUTOMATIC TRANSMISSION: PARK / NEUTRAL POSITION SWITCH:

INSTALLATION

1. INSTALL NEUTRAL START SWITCH ASSEMBLY






(a) Install the park/neutral position switch to the manual valve shaft.
(b) Temporarily install the bolt.






(c) Install a new lock washer and the nut.
Torque: 6.9 Nm (70 kgf-cm, 61 in-lbf)






(d) Temporarily install the control shaft lever.






(e) Turn the control shaft lever counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.






(f) Remove the transmission control shaft lever.






(g) Align the neutral alignment mark line with the switch groove, and tighten the adjusting bolt.
Torque: 13 Nm (130 kgf-cm, 9 ft-lbf)






(h) Using a screwdriver, bend the tabs of the lock washer.






(i) Install the transmission control shaft lever RH with the nut.
Torque: 16 Nm (163 kgf-cm, 12 ft-lbf)






(j) Connect the park/neutral position switch connector.
2. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Installation

3. ADJUST SHIFT LEVER POSITION Adjustments

4. INSPECT SHIFT LEVER POSITION Shift Lever Assembly

5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY Inspection