Removal

BRAKE PEDAL:

REMOVAL

1. PRECAUTION
CAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing. Service Precautions

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE ENGINE ROOM SIDE COVER LH Removal

4. REMOVE ENGINE ROOM SIDE COVER RH Removal

5. REMOVE FRONT UPPER FENDER PROTECTOR LH Removal

6. REMOVE FRONT UPPER FENDER PROTECTOR RH Removal

7. REMOVE ROOF DRIP SIDE FINISH MOULDING LH

8. REMOVE ROOF DRIP SIDE FINISH MOULDING RH Removal

9. REMOVE FRONT WIPER ARM HEAD CAP Removal

10. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH Removal

11. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH Removal

12. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal

13. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

14. SEPARATE NO. 3 ENGINE ROOM RELAY BLOCK
15. REMOVE FRONT WHEEL
16. DRAIN BRAKE FLUID
NOTE: If brake fluid leaks onto any painted surface, wash off or remove the brake fluid completely.

17. REMOVE FRONT DOOR SCUFF PLATE LH (w/o Illumination) Removal

18. REMOVE FRONT DOOR SCUFF PLATE LH (w/ Illumination) Removal

19. REMOVE FRONT DOOR OPENING TRIM COVER LH Removal

20. REMOVE INSTRUMENT SIDE PANEL LH Removal

21. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

22. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Removal

23. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY Removal

24. REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRACKET Removal

25. SEPARATE CLUTCH RESERVOIR HOSE (for Manual Transmission) Removal

26. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY Removal

27. REMOVE BRAKE PEDAL RETURN SPRING Removal

28. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS Removal

29. REMOVE BRAKE BOOSTER ASSEMBLY Removal

30. REMOVE BRAKE BOOSTER GASKET
(a) Remove the brake booster gasket.
31. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY






(a) Disconnect the 2 connectors.






(b) Remove the bolt and brake pedal support assembly.
32. REMOVE STOP LIGHT SWITCH ASSEMBLY
(a) Loosen the lock nut and remove the stop light switch assembly.
33. REMOVE CUSHION
(a) Remove the cushion.
34. REMOVE BRAKE PEDAL PAD
(a) Remove the brake pedal pad.