Removal

BRAKE CONTROL: BRAKE ACTUATOR:

REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL Removal

2. REMOVE ENGINE ROOM SIDE COVER LH Removal

3. REMOVE ENGINE ROOM SIDE COVER RH Removal

4. REMOVE FRONT UPPER FENDER PROTECTOR LH Removal

5. REMOVE FRONT UPPER FENDER PROTECTOR RH
HINT: Use the same procedures for the RH side and the LH side.

6. REMOVE FRONT WIPER ARM HEAD CAP Removal

7. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal

8. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal

9. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal

10. SEPARATE NO. 3 ENGINE ROOM RELAY BLOCK Removal

11. REMOVE FRONT WHEEL
12. DRAIN BRAKE FLUID
NOTE: If brake fluid leaks onto any painted surface, wash or remove it completely.

13. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY Removal

14. REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRACKET






(a) Release the lock lever and disconnect the actuator connector.
(b) Using SST, disconnect the 6 brake tubes from the brake actuator assembly with bracket.
SST: 09023-00101






(c) Use tags or make a memo to identify the places to reconnect.
- *1: To Front Wheel Cylinder RH
- *2: To Front Wheel Cylinder LH
- *3: To Rear Wheel Cylinder RH
- *4: To Rear Wheel Cylinder LH
- *5: From Front Master Cylinder
- *6: From Rear Master Cylinder





(d) Using SST, disconnect the No. 3 front brake tube from the flexible hose.
SST: 09023-00101
(e) Separate the grommet and remove the No. 3 front brake tube.
NOTE: Do not damage the brake tube.





(f) Remove the 2 bolts, nut and brake actuator assembly with bracket from the body.
NOTE: Do not damage the brake tubes.

15. REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY






(a) Remove the 2 nuts and the brake actuator from the actuator bracket assembly.
(b) Remove the brake actuator bolt cushion and actuator bracket.
16. REMOVE BRAKE ACTUATOR BOLT CUSHION






(a) Remove the 2 bolts and the 2 brake actuator bolt cushions from the brake actuator assembly.