Removal

AIR CONDITIONING: BLOWER UNIT: REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL Removal

2. REMOVE ENGINE ROOM SIDE COVER LH Removal

3. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY LH Removal

4. REMOVE FRONT PILLAR TO FRONT SIDE SEAL SUB-ASSEMBLY RH Removal

5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal

6. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal

7. REMOVE FRONT FENDER TO COWL SIDE SEAL LH Removal

8. REMOVE FRONT FENDER TO COWL SIDE SEAL RH Removal

9. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal

10. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY Removal

11. TABLE OF BOLT, SCREW AND NUT Removal

12. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE Removal

13. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

14. REMOVE FRONT DOOR SCUFF PLATE INSIDE RH Removal

15. REMOVE FRONT DOOR SCUFF PLATE INSIDE LH Removal

16. REMOVE FRONT DOOR OPENING TRIM COVER RH Removal

17. REMOVE FRONT DOOR OPENING TRIM COVER LH Removal

18. REMOVE STEERING WHEEL NO. 2 COVER LOWER Removal

19. REMOVE STEERING WHEEL NO. 3 COVER LOWER Removal

20. REMOVE STEERING PAD Removal

21. REMOVE STEERING WHEEL ASSEMBLY
for 2GR-FSE Removal
for 1UR-FSE Removal
22. REMOVE STEERING COLUMN COVER LOWER
for 2GR-FSE Removal
for 1UR-FSE Removal
23. REMOVE STEERING COLUMN COVER UPPER
for 2GR-FSE Removal
for 1UR-FSE Removal
24. REMOVE SPIRAL CABLE WITH STEERING SENSOR Removal

25. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY Removal

26. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY Removal

27. REMOVE FRONT CONSOLE UPPER PANEL ASSEMBLY Removal

28. REMOVE CONSOLE UPPER PANEL ASSEMBLY Removal

29. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

30. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

31. REMOVE CONSOLE BOX PLATE Removal

32. REMOVE CONSOLE BOX REGISTER ASSEMBLY Removal

33. REMOVE CONSOLE BOX Removal

34. REMOVE STEERING COLUMN ASSEMBLY
for 2GR-FSE Removal
for 1UR-FSE Removal
35. REMOVE INSTRUMENT CLUSTER FINISH PANEL Removal

36. REMOVE COMBINATION METER ASSEMBLY Removal

37. REMOVE INSTRUMENT SIDE PANEL RH Removal

38. REMOVE INSTRUMENT SIDE PANEL LH Removal

39. REMOVE INSTRUMENT PANEL NO. 1 UNDER COVER SUB-ASSEMBLY Removal

40. REMOVE INSTRUMENT PANEL NO. 1 SAFETY PAD SUB-ASSEMBLY Removal

41. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY Removal

42. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY Removal

43. REMOVE INSTRUMENT PANEL NO. 2 UNDER COVER Removal

44. REMOVE STEERING CONTROL ECU Removal

45. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Removal

46. REMOVE GLOVE COMPARTMENT DOOR SUB-ASSEMBLY Removal

47. REMOVE FRONT PILLAR GARNISH RH Removal

48. REMOVE FRONT PILLAR GARNISH LH Removal

49. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY Removal

50. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Removal

51. REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY Removal

52. REMOVE NO. 2 AIR DUCT Removal

53. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY Removal

54. REMOVE BLOWER ASSEMBLY






(a) Disconnect the connector.
(b) Remove the screw and nut.
(c) Detach the 2 claws and remove the blower.