Removal

NAVIGATION: NAVIGATION ANTENNA: REMOVAL

1. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

3. REMOVE FRONT DOOR SCUFF PLATE LH Removal

4. REMOVE FRONT DOOR SCUFF PLATE RH Removal

5. REMOVE FRONT DOOR OPENING TRIM COVER LH Removal

6. REMOVE FRONT DOOR OPENING TRIM COVER RH Removal

7. REMOVE NO. 3 STEERING WHEEL COVER LOWER Removal

8. REMOVE NO. 2 STEERING WHEEL COVER LOWER Removal

9. REMOVE STEERING PAD Removal

10. REMOVE STEERING WHEEL ASSEMBLY Removal

11. REMOVE STEERING COLUMN COVER Removal

12. REMOVE SPIRAL CABLE WITH STEERING SENSOR Removal

13. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY Removal

14. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY Removal

15. REMOVE FRONT CONSOLE UPPER PANEL GARNISH Removal

16. REMOVE CONSOLE UPPER PANEL ASSEMBLY Removal

17. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

18. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

19. REMOVE CONSOLE BOX PLATE Removal

20. REMOVE CONSOLE BOX REGISTER ASSEMBLY Removal

21. REMOVE CONSOLE BOX Removal

22. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Removal

23. REMOVE COMBINATION METER ASSEMBLY Removal

24. REMOVE INSTRUMENT SIDE PANEL LH Removal

25. REMOVE INSTRUMENT SIDE PANEL RH Removal

26. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

27. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Removal

28. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY Removal

29. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY Removal

30. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

31. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Removal

32. REMOVE GLOVE COMPARTMENT DOOR SUB-ASSEMBLY Removal

33. REMOVE FRONT PILLAR GARNISH LH Removal

34. REMOVE FRONT PILLAR GARNISH RH Removal

35. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY Removal

36. CONFIRM RADIO RECEIVER ASSEMBLY SHIPMENT MODE SETTING Removal

37. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Removal

38. REMOVE SIDE NO. 1 DEFROSTER NOZZLE DUCT Disassembly

39. REMOVE NO. 1 HEATER TO REGISTER DUCT Disassembly







40. REMOVE NAVIGATION ANTENNA
(a) Remove the 3 screws and detach the 4 clips to remove the antenna.