Ex-11

SRS DTC Troubleshooting: Ex-11 (x can be 0 thru 9 or A thru F)

DTC Ex-11 ("x" can be 0 thru 9 or A thru F):Control Operation Recorded

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures Technician Safety Information and General Troubleshooting Information. Initial Inspection and Diagnostic Overview

1. Clear the DTC memory. Initial Inspection and Diagnostic Overview

2. Turn the ignition switch to ON (II), then wait for 10 seconds.

3. Read the DTC. Initial Inspection and Diagnostic Overview

Is DTC Ex-11 indicated?
YES - Faulty SRS unit; replace the SRS unit. SRS Unit Replacement

NO - Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. Initial Inspection and Diagnostic Overview If another DTC is indicated, troubleshoot the DTC.