B2-8x

SRS DTC Troubleshooting: B2-17, B2-8x, B2-9x, B2-Ax, B2-Bx (x can be 0 thru 9 or A thru F)

DTC B2-17, B2-8x, B2-9x, B2-Ax, B2-Bx ("x" can be 0 thru 9 or A thru F): Internal Failure of the Rear Safing Sensor

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures Technician Safety Information and General Troubleshooting Information. Initial Inspection and Diagnostic Overview

1. Clear the DTC memory. Reading and Clearing Diagnostic Trouble Codes

2. Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is B2-17, B2-8x, B2-9x, B2-Ax, or B2-Bx indicated?
YES - Replace the rear safing sensor, Service and Repair then clear the DTC. If the DTC returns, replace the SRS unit. SRS Unit Replacement

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. Initial Inspection and Diagnostic Overview If another DTC is indicated, troubleshoot the DTC.