Pinpoint Test W: The High Beam Indicator Is Never/Always On

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test W: The High Beam Indicator Is Never/Always On

Normal Operation

When the high beams are turned on, the Smart Junction Box (SJB) sends a signal to the Instrument Cluster (IC) through the communication network to illuminate the high beam indicator.

This pinpoint test is intended to diagnose the following:

- SJB
- IC



PINPOINT TEST W: THE HIGH BEAM INDICATOR IS NEVER/ALWAYS ON

-------------------------------------------------
W1 CHECK THE HIGH BEAM HEADLAMPS OPERATION


- Ignition ON.
- Place the headlamp switch in the HIGH BEAMS ON position. Observe the high beam headlamps.
- Do the high beam headlamps operate correctly?

Yes
GO to W2.

No
REFER to Headlamp. Testing and Inspection

-------------------------------------------------
W2 CARRY OUT THE IC INDICATOR LAMP CONTROL ACTIVE COMMAND USING THE SCAN TOOL


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IC DataLogger.
- Select the IC high beam indicator (HIGH_BEAM) active command on and off while monitoring the high beam indicator.
- Does the high beam indicator illuminate when commanded on, and turn off when commanded off?

Yes
INSTALL a new SJB. TEST the system for normal operation.

No
INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.

-------------------------------------------------