Instrument Cluster (IC)

Instrument Cluster (IC)









Removal and Installation

1. NOTE: If installing a new Instrument Cluster (IC), it is necessary to upload the IC configuration information to the scan tool.

Depower the Supplemental Restraint System (SRS). For additional information, refer to Air Bag Systems.

2. NOTE: The IC finish panel is held in place with retaining clips that are attached to the bezel.

Remove the IC finish panel.

3. Remove the 4 screws and the IC.
- Disconnect the electrical connector.

4. To install, reverse the removal procedure.
- If a new IC was installed, download the IC configuration information from the scan tool into the new IC.