DT2 Check For Unwarranted ABS Activity

DT2 CHECK FOR UNWARRANTED ABS ACTIVITY

- Drive vehicle at approximately 32 km/h (20 mph).

- Perform a light to medium (normal traffic) stop.

NOTE:
- When conducting the following procedure, the vehicle may pull as soon as the pump motor turns on. The front brake anti-lock sensor opposite the pull should be check using the ABS Misfire, ABS Too Sensitive, and ABS Fires On Normal Stop symptoms of the Symptom Chart.

- If the pump motor turns on and no pull is felt, the rear brake anti-lock sensors should be check using the ABS Misfire, ABS Too Sensitive, and ABS Fires on Normal Stop conditions of the Symptom Chart.

- If a vehicle pulls immediately upon braking and the pump motor does not turn on, use the Vehicle Pulls During Braking symptom of the Symptom Chart to diagnose the concern. Symptom Related Diagnostic Procedures

- Turn off the windshield wipers.

- Perform a light to medium (normal traffic) stop.

Does the pump motor turn on and are brake pedal pulsations felt at any time during the stop?

> Yes
If the yellow ABS warning indicator is not on, go to ABS Misfire, ABS Too Sensitive, ABS Fires On Normal Stop, in the Symptom Chart. Symptom Related Diagnostic Procedures

If the yellow ABS warning indicator comes on and stays on, go to Drive Cycle Test DT7. DT7 Obtain Diagnostic Trouble Code

> No
If other symptoms are detected are detected, Go to Drive Cycle Test DT6. DT6 Determine Next Diagnostic Step Based on Brake Symptom

If the yellow ABS warning indicator is not on, go to Drive Cycle Test DT3. DT3 Check For Marginally High Sensor Gap (at Idle)