Windshield Washer Reservoir - Removal

REMOVAL





1. Disconnect and isolate the battery negative cable.
2. Remove the ElectroHydraulic Power Steering (EHPS) pump from the outboard side of the right frame rail. Power Steering Pump - Removal.
3. Disconnect the headlamp and dash wire harness (1) connector for the washer pump (5) from the washer pump motor (7) connector receptacle.
4. Disconnect the headlamp and dash wire harness connector for the washer fluid level switch (6) from the switch (3) connector receptacle.
5. Disconnect the washer hose (2) from the barbed outlet nipple of the washer pump and allow the washer fluid to drain into a clean container for reuse.





6. Remove the two screws (2) that secure the washer reservoir (1) to the outboard side of the right frame rail (3).
7. Lower the washer reservoir from the vehicle, rotating it as necessary for clearance.