Transmission Fill After Service

STANDARD PROCEDURE - TRANSMISSION FILL AFTER SERVICE

CAUTION: A unique transmission fluid has been developed for the 8HP45 transmission. This fluid is NOT compatible with ATF+4 or any other current Chrysler transmission fluid. For specifics about this unique fluid see FLUIDS, LUBRICANTS AND GENUINE PARTS .

To properly fill the transmission after an in vehicle service or overhaul, perform the following procedure:

NOTE: If the transmission cooler was replaced, add an additional 0.7L (0.72 qts) of transmission fluid.

1. If the transmission was overhauled, prior to installing in the vehicle, tip the transmission on it side, remove the oil fill plug on the right rear side of the case and install 9L (9.5 qts) of transmission fluid. Install the fill plug. After installing the transmission, perform the CHECK OIL LEVEL procedure . Check Oil Level
2. If an in vehicle service was performed, raise and support the vehicle on a level hoistMaintenance , remove the oil fill plug on the right rear side of the case and install transmission fluid until it drips from the fill hole. Install the fill plug and perform the CHECK OIL LEVEL procedure . Check Oil Level