Check Oil Level

STANDARD PROCEDURE - CHECK OIL LEVEL

To properly check and fill the transmission, perform the following procedure:

WARNING: There is a risk of accident from vehicle starting off by itself when engine running. There is a risk of injury from contusions and burns if you insert your hands into the engine when it is started or when it is running. Secure vehicle to prevent it from moving off by itself. Wear properly fastened and close-fitting work clothes. Do not touch hot or rotating parts.

CAUTION: A unique transmission fluid has been developed for the 8HP45 transmission. This fluid is NOT compatible with ATF+4 or any other current Chrysler transmission fluid. For specifics about this unique fluid see FLUIDS, LUBRICANTS AND GENUINE PARTS .

1. Raise and support the vehicle on a level hoistMaintenance.
2. Start the engine.
3. Using a scan tool or the vehicle information center, verify that the transmission fluid temperature is below 30°C (86°F).
4. Disable traction control (ESC).
5. Remove the fill plug from the right rear of the transmission case.
6. Add transmission fluid until it trickles from the fill opening.
7. Install the fill plug.
8. Lower the vehicle for access to inside of the vehicle, leaving the tires at least 8 inches off the ground.
9. With the brakes applied, place the transmission in Reverse and hold for 5 seconds.
10. Place the transmission in Drive and hold for 5 seconds.
11. Release the brakes, slowly accelerate to 2nd gear and hold for 5 seconds.
12. Apply the brakes and place the transmission in Neutral.
13. Raise the engine speed to 2000 RPM for 5 seconds.
14. Return the engine to idle and place the transmission in Park.

NOTE: A full transmission will have fluid at the fill hole with the transmission between 30°C (86°F) and 50°C (122°F). Do not over fill.

15. Remove the fill plug and allow excess fluid to drain from fill hole or add fluid as necessary.
16. Install the fill plug.
17. Using a scan tool, clear any DTCs.