Parking Brake Lever - Removal - RHD

LEVER - RHD

NOTE: Before proceeding, Warning Brakes - Caution .

1. Raise and support vehicle. Maintenance






NOTE: Due to short travel and low spring tension, it is not necessary to lock-out parking brake lever to service parking brake components.

2. Disconnect front parking brake cable (5) at connector (2) to right rear parking brake cable.
3. Lower vehicle.

4. Remove driver side silencer under instrument panel.Silencer Panel - Installation
5. Remove steering column opening cover. Steering Column Opening Cover - Installation
6. Remove foot rest. Front Floor Foot Rest - Removal
7. Roll back carpet at center console to access lever mounting nuts.





8. Disconnect wiring connector at parking brake switch on lever.
9. Disconnect front parking brake cable strand (3) at lever connector (2).










10. Place 13 mm 12-point box wrench (2) over cable retainer (1) at lever bracket as shown to collapse retainer fingers. Pull cable from bracket.





11. Loosen nut (5) mounting parking brake lever (7) to body.
12. Remove nuts (8) mounting parking brake lever (7) to body.
13. Remove parking brake lever (7).