Front Floor Foot Rest - Removal

REMOVAL





1. Remove the trim from the driver side lower cowl side inner panel. Cowl Trim Panel - Removal.
2. Remove the push-pin fastener that secure the driver side front carpet to the cowl side inner panel and the front door opening sill.
3. Pull the front floor carpet up and away from the foot rest (1) far enough to access and remove the nut (2) that secures the foot rest to the weld stud (5) on the front floor panel.
4. Lift the base of the foot rest upward far enough to disengage the tab (3) at the top of the foot rest from the slot (4) in the dash panel.





5. (if equipped) Turn foot rest over and disconnect the DTCM connector (1) from the DTCM (2).
6. Remove the foot rest (3) from the vehicle.