Radio Frequency Module (RF Hub) - Installation

INSTALLATION

NOTE: Replace and Program the module(s) per the RF-Hub, BCM, PCM FOBIK and ELV Replacement and Programming Order Guide . RF Hub, BCM, PCM, FOBIK, And ELV Replacement And Programming Order





1. Position into place and install the RF Hub (4) and retainers (1).
2. Connect the electrical connectors (2).
3. If equipped, connect the remote start antenna (3).
4. Install the rear shelf cover Rear Shelf Panel - Installation.
5. Connect the Intelligent Battery Sensor (IBS) to the negative battery post.

NOTE: Program the RF-Hub RF Hub, BCM, PCM, FOBIK, And ELV Replacement And Programming Order