Rear Shelf Panel - Installation

INSTALLATION





1. Position the trim (2) onto the rear shelf panel (3).
2. Slide the rear edge of the trim rearward to engage the lens bezel of the center high-mounted stop lamp and far enough to engage the S-clip that secures the underside of the trim to the center of the shelf panel.
3. Install the push-pin fastener (1) that secures the trim to the rear shelf panel.
4. Pull the center rear seat belt lower anchor and belt webbing from the retractor through the opening in the top of the rear shelf panel trim and back down to the stud on the floor panel.
5. Install and tighten the nut that secures the seat belt lower anchor to the stud on the floor panel. Tighten the nut to 34 Nm (25 ft. lbs.).
6. Reinstall the right and left upper and lower C-pillar trim to the vehicle. C-Pillar Trim Panel - Installation.
7. Reconnect the battery negative cable.