Sentry Key Remote Entry Module - Removal

REMOVAL





1. Open hood, disconnect and isolate the battery negative cable.

WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, personal injury or death.

2. Remove knee blocker airbag Knee Blocker Airbag - Removal.
3. Unsnap instrument panel center stack left bezel (13) from instrument panel assembly (12).




4. Reach up behind the left side of the center stack and disconnect the ignition switch and SKREEM electrical connectors (5 and 6).




5. From underneath the ignition switch/lock assembly, loosen the lower retaining screw (2).
6. Remove the two mounting nuts (1) from the front of the instrument panel.
7. Push the ignition switch/lock assembly (3) inward toward the bulkhead.




8. Remove the SKREEM mounting screw (1) on the ignition lock assembly and separate the SKREEM from the ignition lock assembly.