Right Rear

REMOVAL

1. Lock out automatic adjuster in parking brake lever. Service and Repair
2. Raise and support vehicle. Maintenance

NOTE: It may be necessary to back off parking brake shoe adjustment to allow sufficient slack to disengage cable buttons from connectors in following two steps.





3. Slide left rear cable button (11) inboard and remove from equalizer (10).
4. While holding cable connector on end of front cable (5) secure with a pair of pliers at the front cable button, slide right rear cable button (4) inboard and remove from cable connector.
5. Access and remove rear hub and bearing. Rear Hub / Bearing - Removal




6. Remove parking brake cable bolt (1) at knuckle.
7. Remove parking brake shoes from support. Removal




8. Remove shoe actuator (1) from end of cable (2) and support.
9. Pull cable out of support plate and knuckle.




10. Place a 13 mm 12-point box wrench (2) over cable retainer (1) on end of cable housing at crossmember and collapse retainer fingers.
11. Remove cable.