Cruise Control Module: Service and Repair

REMOVAL PROCEDURE



1. Disconnect the negative battery cable.
2. Remove the IP Compartment.
3. Disconnect the cruise control module electrical connector.
4. Remove the following components from the vehicle:
^ The cruise control module mounting bolt
^ The cruise control module (2)

INSTALLATION PROCEDURE



1. Install the cruise control module (2) to the IP. Secure the module with the mounting bolt.

Tighten
Tighten the cruise control module mounting bolt to 10 N.m (89 lb in).

2. Connect the cruise control module electrical connector.
3. Install the I/P Compartment.
4. Connect the negative battery cable.