Selector and Shift Lever Cable Bracket Replacement

Selector and Shift Lever Cable Bracket Replacement

Removal Procedure

1. Remove battery tray. Refer to Battery Tray Replacement Battery Tray Replacement.





2. Use a suitable tool to remove the shift lever and selector lever cable (2) from transmission control housing (3).

3. Remove shift lever and selector lever cable from shift lever and selector lever cable bracket (1).





4. Remove 2 shift lever and selector lever cable bracket nuts (2).

5. Remove shift lever and selector lever cable bracket (1).

Installation Procedure





1. Install shift lever and selector lever cable bracket (1).

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install 2 shift lever and selector lever cable bracket nuts (2) and tighten to 20 Nm (15 lb ft).





3. Install shift lever and selector lever cable (2) to shift lever and selector lever cable bracket (1).

4. Install shift lever and selector lever cable to transmission control housing (3).

5. Adjust the shift lever and selector lever cable. Refer to Manual Transmission Shift Lever and Selector Lever Cable Adjustment Manual Transmission Shift Lever and Selector Lever Cable Adjustment.

6. Install battery tray. Refer to Battery Tray Replacement Battery Tray Replacement.