Electro-Mechanical Steering Gear Overview

Electro-Mechanical Steering Gear Overview






1 Universal Joint

2 Bolt

• 20 Nm + 90° turn

• Always replace if removed.

3 Electrical Wiring

4 Power Steering Gear

• Removing and installing => [ Steering Gear ] Steering Gear

• For the correct allocation, refer to the parts catalog.

• When converting from Generation II steering gear to Generation II, the electrical wire - 3 - must also be replaced.

• With power steering control module (J500)

• Can be tested in "Guided Fault Finding" using the vehicle diagnostic tester.

5 Wheel Bearing Housing

6 Nut

• 20 Nm + 90° turn

• Always replace if removed.

7 Subframe with Brackets

8 Bolt

• 50 Nm + 90° turn

• Always replace if removed.

• Three bolts installed with the Generation III steering gear.

9 Clamp with Nuts

• Removing and installing => [ Generation II Steering Gear Bonded Rubber Bushing ] Generation II Steering Gear Bonded Rubber Bushing

• Always replace if removed.

• Only installed with Generation II steering gear.

10 Heat Shield

11 Bolt

• 6 Nm