Generation II Steering Gear Bonded Rubber Bushing

Generation II Steering Gear Bonded Rubber Bushing

Removing

- Remove the lower noise insulation. Refer to "Underbody Trim Panels and Heat Shields".

- Remove the bolts - 2 - and - 3 - and push the heat shield - 4 - slightly upward.






- Loosen the steering gear bolts - 1 - and - 4 - on the left side of the vehicle.






- Loosen the steering gear bolts - 2 - and - 3 - on the right side of the vehicle and remove them.

The illustration shows a removed subframe with steering gear.

- Raise the steering gear - 4 - on the right side of the vehicle up slightly.






- Remove the clamp - 1 - and rubber bushing - 2 - with the bracket - 3 - from the steering gear.

Installing

Install in reverse order of removal. Note the following:

Torque specifications => [ Electro-Mechanical Steering Gear Overview ] Electro-Mechanical Steering Gear Overview.