Airbag Control Module J234

Airbag Control Module J234

Removing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Service Precautions.

- Switch off the ignition.

- Clamp off ground wire at battery with ignition switched off.

- Remove front center console. Refer to => [ Front Center Console ] Front Center Console.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Open securing clip at connector - 1 -.






- Remove connector - 1 -.

- Remove nuts - 3 - (quantity: 3) from threaded pins.

- Remove Airbag Control Module (J234) - 2 - from threaded pins.

Installation

Install in reverse order of removal. Note the following:

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Service Precautions.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

• Make sure the connectors are installed all the way in and are secure.

- Switch on ignition.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect battery ground cable with ignition switched on.

- If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.

• After replacing control module, it must be coded.

• The airbag control module (J234) ground connection is achieved via the housing with the body.

For the correct tightening specifications; refer to => [ Airbag Control Module J234 Assembly Overview ] Airbag Control Module J234 Assembly Overview.