Electronic Damping Control Module (J250), With Electronically Controlled Damping

Electronic Damping Control Module (J250), with Electronically Controlled Damping

Removing

• The electronic damping control module is located behind the right luggage compartment side trim panel.

- Switch off all electrical consumers.

- Remove the ignition key.

- Remove the cover from the right luggage compartment storage compartment.

- Release and disconnect the connector - 3 -.






- Press the clips - 2 - to the side and remove the electronic damping control module - 1 -.

Installing

Installation is the reverse of removal, with special attention to the following:

- Adapt the electronic damping control module. Refer to => [ Control Position, Programming using Vehicle Diagnostic Tester ] Testing and Inspection.