Power Convertible Top Valves (N272)/(N341)/(N342)

Power Convertible Top Valves (N272)/(N341)/(N342)

Injury risk.

• There must be no pressure inside the hydraulic system when performing the following work.

Removing

- Remove hydraulic pump. Refer to => [ Hydraulic Pump ] Hydraulic Pump.

Risk of damage.

• Carefully release the connector from the valve with a small screwdriver. Do not break the locking mechanism.

- Disconnect the connector - 1 -.






- Remove the bolt - 3 -.

- Remove it by lightly turning the valve - 2 - out of the valve block - 4 -.

Installation

• Tightening specifications, refer to => [ Motor Overview and Hydraulic Pump Fluid Reservoir ] Motor Overview and Hydraulic Pump Fluid Reservoir.

Install in reverse order of removal. Note the following:

- Make sure the hole for the valve is clean.

- Install the replacement valve into the hole and tighten the screws to the tightening specification.

- Install hydraulic pump. Refer to => [ Hydraulic Pump ] Hydraulic Pump.

- Check the fluid level and fill with fluid if necessary. Refer to => [ Hydraulic System, Filling and Bleeding ] Hydraulic System, Filling and Bleeding.