Intake Manifold Overview

Intake Manifold Overview

• The illustration shows the intake manifold upper section with the lower left section.






1 Clamp

• 5.5 Nm

• Reinforced

2 Throttle Valve Control Module (J338)

• 9 Nm

3 O-ring

• Replace

4 Bolt

• 9 Nm

• Fasten in diagonal sequence in steps

5 Bolt

• 9 Nm

6 Gasket

• Replace

7 Connecting Pipe for Exhaust Gas Recirculation (EGR)

8 Upper Intake Manifold

• Removing and installing, refer to => [ Upper Intake Manifold ] Upper Intake Manifold

9 Seal

• Replace

10 Drain Plug

• 10 Nm

11 Bolt

• 9 Nm

12 Engine Cover Bolt

• 5 Nm

13 Bolt

• 9 Nm

14 Gasket

• Check and replace if damaged

15 Intake Flap Motor

• Cylinder bank 1 (right): Intake Flap Motor (V157)

• Cylinder bank 2 (left): Intake Flap Motor 2 (V275)

16 Bolt

• 10 Nm

17 Clip

18 Connecting Rod

19 Support

20 Lower Intake Manifold

21 Gasket

• Check and replace if damaged

22 Air Guide Hose

• Must be free of oil and grease when installing