Windshield Wiper Motor With Wiper Motor Control Module

Windshield Wiper Motor with Wiper Motor Control Module

Observe notes on contact corrosion => [ Contact Corrosion ] Service Precautions.

Removal

- Remove the windshield wiper arms. Refer to => [ Windshield Wiper Arms ] Removal and Replacement.

- Remove the plenum chamber cover and cowl panel trim.

- Remove the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

- Release the retainer - arrow -, remove the engine control module - 1 - and move it to the side with the wires still connected.






• Disregard item - 2 -.

- Disconnect the connector - 2 - and free up the wiring harness - 3 -.






- Open the retainers - arrows - and remove the mount - 1 - downward.

- Remove the screws - 2, 4 and 5 -.






- Move the windshield wiper frame - 3 - with the linkage and windshield wiper motor slightly forward - arrow -.

- Free up the wiring harness - 1 - on the windshield wiper frame.

- Remove the windshield wiper frame - 3 - with the linkage and windshield wiper motor from the plenum chamber between the gas-filled strut - 1 - and the hood hinge - 2 -.






Installation

• Tightening specification, refer to => [ Windshield Wiper Motor, Tightening Specifications and Sequence ] Windshield Wiper System Overview.

Install in reverse order of removal, observing the following:

- Install the windshield wiper motor and the windshield wiper frame.

- Tighten bolts, refer to => [ Windshield Wiper Motor, Tightening Specifications and Sequence ] Windshield Wiper System Overview.

- Press the cowl panel trim mount onto the body until it clicks into place.

- Install the engine control module.

- Install the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

- Install the cowl panel and plenum chamber cover.

- Adjust the windshield wiper arms. Refer to => [ Windshield Wiper Arms, Adjusting ] Adjustments.