Windshield Wiper System Overview

Windshield Wiper System Overview

Observe notes on contact corrosion, refer to => [ Contact Corrosion ] Contact Corrosion.






1 Screw

2 Windshield Wiper Motor (V)

• With Wiper Motor Control Module (J400)

• Removing and installing, refer to => [ Windshield Wiper Motor with Wiper Motor Control Module ] Windshield Wiper Motor With Wiper Motor Control Module.

• Replacing, refer to => [ Windshield Wiper Motor and Wiper Motor Control Module, Replacement ] Windshield Wiper Motor and Wiper Motor Control Module, Replacement.

3 Screw

4 Nut

• 22 Nm

5 Cap

6 Windshield Wiper Arm, Passenger's Side

• Different lengths. Refer to Electronic Parts Catalog (ETKA).

• Removing and installing, refer to => [ Windshield Wiper Arms ] Removal and Replacement.

• Adjusting, refer to => [ Windshield Wiper Arms, Adjusting ] Adjustments.

7 Windshield Wiper Blade, Passenger's Side

• Different lengths. Refer to Electronic Parts Catalog (ETKA).

• Replacing, refer to => [ Windshield Wiper Blades, Replacing ] Service and Repair.

8 Windshield Wiper Blade, Driver's Side

• Different lengths. Refer to Electronic Parts Catalog (ETKA).

• Replacing, refer to => [ Windshield Wiper Blades, Replacing ] Service and Repair.

9 Windshield Wiper Arm, Driver's Side

• Different lengths. Refer to Electronic Parts Catalog (ETKA).

• Removing and installing, refer to => [ Windshield Wiper Arms ] Removal and Replacement.

• Adjusting, refer to => [ Windshield Wiper Arms, Adjusting ] Adjustments.

10 Cap

11 Nut

• 22 Nm

12 Screw

Windshield Wiper Motor, Tightening Specifications and Sequence






- Tighten the bolts in - 1, 2, 3 - sequence in 2 stages as follows:

1. Install by hand as far as the stop.

2. Tighten to 8 Nm.