Fuse Panel A, Luggage Compartment

Fuse Panel A, Luggage Compartment

Removing






- With the ignition turned off, disconnect the battery ground cable. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the tool kit mount - 1 -.

- Remove the subwoofer - 1 -.

• If it not possible to remove fuse panel A from the battery terminal, then remove the bolt - 4 - on the battery bracket - 3 - and pull the battery - 2 - just a little to the left - arrow -.

- Loosen the nut - 1 - several turns and remove the battery positive wire terminal clamp with the fuse panel A from the battery terminal.






- Release the spring - 3 - and open the cover - 2 - over fuse panel A - arrow -.

- Disconnect electrical wires - 1, 5, 6 and 8 -.






- Remove the positive terminal clamp - 4 - and fuse panel A from the battery pole.

- Remove the battery interrupt igniter (N253) - item 7 -.

- Remove fuse panel A.

• Check the exact assignment for fuse panel A in the current wiring diagram.

Installing

• Tightening specification, refer to => [ Fuse Panel A Bolt Tightening Specifications ] Engine Compartment E-Box, Wire Junction, Fuse Holder and Battery Overview.

Install in reverse order of removal, observing the following:

- Install the battery interrupt igniter.

- Install the retaining bracket. Refer to => [ Installing ] Battery.

- Connect the battery. Required actions, refer to => [ Connecting ] Battery, Disconnecting and Connecting.