02EA Transmission

Transmission Input Speed Sensor (G182)/Clutch Oil Temperature Sensor (G509)

• Transmission input speed sensor and clutch oil temperature sensor are put into one component and can only be replaced together.

Removing


Risk of transmission damage.

• Do not run engine or tow vehicle with oil pan removed or without transmission fluid.

• Refer to => [ Repair Information ] 02EA Transmission.

• Refer to => [ Clean Working Conditions ] Clean Working Conditions.

- Remove the ATF pan. Refer to => [ Oil Pan ] 02EA Transmission.

- Remove DSG transmission Mechatronic (J743). Refer to => [ DSG Transmission Mechatronic (J743) ] 02EA Transmission.

- Remove bolt - B -.







Risk of damaging electrical wire.

• Do not pull on electrical wire.

- Remove transmission input speed sensor and clutch oil temperature sensor - A - together with wire - C - from transmission.

Installing

Install in reverse order, paying attention to the following:

• Tightening specifications, refer to => [ Oil Pan, Mechatronic and Transmission Fluid Pump Overview ] Oil Pan, Mechatronic and Transmission Fluid Pump Overview.

- Coat transmission input speed sensor and clutch oil temperature sensor with gear oil.

- Insert transmission input speed sensor and clutch oil temperature sensor in side opening on transmission and tighten => [ / ] Oil Pan, Mechatronic and Transmission Fluid Pump Overview.

- Install DSG transmission Mechatronic. Refer to => [ DSG Transmission Mechatronic (J743) ] 02EA Transmission.

- Install the oil pan. Refer to => [ Oil Pan ] 02EA Transmission.

- Be sure to follow the procedure for connecting the battery and afterwards.

- Top off transmission oil and check oil level. Refer to => [ Transmission Fluid, Replacing or Filling after Repair ] Transmission Fluid, Replacing or Filling After Repair.

- Basic Setting execute vehicle diagnostic tester.