Subframe Mount Overview
Subframe Mount Overview
1 Bolt
• 40 Nm plus an additional 90° turn
• Replace
• Transmission support to transmission
2 Bolts
• 50 Nm plus an additional 90° turn
• Replace
• Pendulum support to transmission
• Different lengths and tightening specifications
3 Engine Support
• There are different versions, refer to the Electronic Parts Catalog (ETKA)
4 Bolt
• Engine support to engine
• Different lengths
5 Engine Mount
• With support arm
6 Bolt
• Engine mount to body
7 Connecting Bar
8 Bolt
• Connecting bar to body
9 Bolt
• Connecting bar to engine
10 Bolt
• Engine mount to body
11 Bolts
• Engine mount to engine support
12 Pendulum Support
• Removing and Installing, refer to => [ Pendulum Support ] Pendulum Support
13 Bolt
• 100 Nm plus an additional 90° turn
• Replace
• Pendulum support to subframe
14 Bolt
• 60 Nm plus an additional 90° turn
• Replace
• Transmission mount to transmission support
15 Bolt
• 40 Nm plus an additional 90° turn
• Replace
• Transmission mount to chassis
16 Transmission Mount
• With support arm
• Removing and Installing:
• Vehicles with 2.0L TFSI engine, refer to => [ Transmission Mount and Transmission Support ] Transmission Mount and Transmission Support
• Vehicles with 3.2L MPI engine, refer to=> [ Transmission Mount and Transmission Support ] Transmission Mount and Transmission Support
• Tightening specification and sequence, refer to => [ Transmission Side Subframe Mount Tightening Sequence ]
17 Bolt
• 40 Nm plus an additional 90° turn
• Replace
• Transmission support to transmission
18 Bolt
• 40 Nm plus an additional 90° turn
• Replace
• Transmission support to transmission
19 Transmission Support
• Removing and Installing, refer to:
• Vehicles with 2.0L TFSI engine, refer to => [ Transmission Mount and Transmission Support ] Transmission Mount and Transmission Support
• Vehicles with 3.2L MPI engine, refer to => [ Transmission Mount and Transmission Support ] Transmission Mount and Transmission Support
• Tightening sequence, refer to => [ Transmission Side Subframe Mount Tightening Sequence ]
Transmission Side Subframe Mount Tightening Sequence
- Install the transmission support - A - between transmission and transmission mount support arm.
- Mount the transmission support to the transmission.
- Raise transmission to transmission mount support arm with engine support bridge (10 - 222 A) spindle.
- Next, install bolts - 2 -, but only hand tight.
Risk of damaging the threads in the transmission support by inserting bolts crooked.
• Before installing bolts - 2 -, transmission support and transmission mount support arm must be absolutely parallel to each other. If necessary, raise rear of transmission with trolley jack.
- Only tighten bolts if subframe is installed.