Pendulum Support

Pendulum Support

Removing






- Remove the noise insulation - 1 -. Refer to "Underbody Trim Panels and Heat Shields".

- Remove the bolts - 1, 2 and 3 - and remove the pendulum support.






Installing

Install in reverse order, paying attention to the following:

• For the correct tightening specifications, refer to => [ Subframe Mount Overview ] Subframe Mount Overview.

- Attach the pendulum support to the transmission, bolts - 2 and 3 - and then to the subframe - 1 -.

- Install the noise insulation. Refer to "Underbody Trim Panels and Heat Shields".