Coil Spring Suspension Strut, Upper Control Arm, Mounting Bracket and Level Control System Sensor Assembly Overview
Coil Spring Suspension Strut, Upper Control Arm, Mounting Bracket and Level Control System Sensor Assembly Overview
1 Bolt
• 50 Nm + 90° turn
• Always replace after removing it.
2 Mounting Bracket
• Removing and installing, refer to => [ Mounting Bracket, with Coil Spring Suspension ] Service and Repair.
3 Securing Clip
4 Nut
• Self-locking
• 50 Nm + 90° turn
• Always replace after removing it.
5 Bolt
• 5 Nm
6 Level Control System Sensors (G78) / (G289)
• Removing and installing, refer to => [ Front Level Control System Sensor ] Front Level Control System Sensor.
7 Nut
• Self-locking
• 85 Nm
• Always replace after removing it.
8 Drive Axle
9 Backing Plate
10 Bolt
• M10: 50 Nm + 90° turn
• M12: 90 Nm + 90° turn
• Always replace after removing it.
11 Tie Rod
• Conical pin must be free of grease and oil.
• If necessary, clean using dry rag, do not use cleaning agents.
12 Nut
• Self-locking
• 90 Nm
• Always replace after removing it.
13 Wheel Bearing Housing
• Conical bores must be free of grease and oil.
• If necessary, clean using dry rag, do not use cleaning agents.
14 Nut
• Self-locking
• 500 Nm
• Always replace after removing it.
• Before assembling, coat contact surface with assembly paste.
15 Bolt
16 Nut
• Self-locking
• 110 Nm
• Always replace after removing it.
17 Stabilizer Bar
18 Coupling Rod
19 Bolt
20 Nut
• Self-locking
• 150 Nm + 90° turn
• Always replace after removing it.
21 Lower Control Arm
• Conical pin must be free of grease and oil.
• If necessary, clean using dry rag, do not use cleaning agents.
22 Bolt
• Always replace after removing it.
23 Nut
• Self-locking
• 110 Nm
• Always replace after removing it.
24 Nut
• Self-locking
• 30 Nm
• Always replace after removing it.
25 Suspension Strut
• Removing and installing, refer to => [ Coil Spring Suspension Strut ] Coil Spring Suspension Strut.
• When removing, leave mounting bracket on vehicle.
26 Nut
• Self-locking
• 7 Nm
27 Upper Control Arm
• Removing and installing, refer to => [ Upper Control Arm, with Coil Spring Suspension ] .
• Conical pin must be free of grease and oil.
• If necessary, clean using dry rag, do not use cleaning agents.
28 Bolt
• Always replace after removing it.
29 Bolt
• Always replace after removing it.
30 Nut
• Self-locking
• 50 Nm + 90° turn
• Always replace after removing it.